Commands Not Appearing
Are your bot's commands not appearing? Here are a few fixes:
- Sync and Refresh
- Sync the command with Discord from the button in the Inventor trigger config. Then reload your Discord client.
- Don't spam the sync button! That's could cause your bot to be rate-limited, which could further delay the appearance of the commands.
- Wait up to thirty minutes
- Ensure the bot is in the server
- Make sure the bot is in the server and is able to create commands.
- If you used an invite link other than the one Inventor supplies from the sidebar, check that
Installation > Default Install Settings
has bothapplication.commands
andbot
enabled, then invite the bot again.
- Ensure you have permissions to see commands
- Make sure the Integrations tab or Inventor trigger permissions aren't restricting your ability to see commands.
- Ensure the command isn't "Age Restricted"
- Make sure you didn't accidentally restrict the command to NSFW-designated Discord channels only. You can find the setting in the Trigger page of the flow.
- Check for sync errors
- Go to the Application Command and check for any errors at the top of the page.
If you're still having trouble, please share all relevant screenshots of the above steps and anything else you've tried in the appropriate Inventor support channels.